⚠️ Only install the requirements from ONE option

NeoForge Requirements:

Option 1 (1.21 and 1.21.1)

Option 2 (1.20.3 to 1.21.5)

Forge Requirements:

Option 2 (1.18.2 or 1.19.2)

Option 3 (1.20.1, 1.21 or 1.21.1)

Option 4 (1.12 to 1.12.2 + 1.14 to 1.21.5)

Option 5 (Not recommended)

Fabric/Quilt Requirements:

Option 1 (Highly recommended) (1.18.2 to 1.21.5)

  • Continuity – (Only supports Emissive textures on version 1.18.2 or higher)
  • Sodium - (Not needed but I highly recommend this)
  • Indium - (Only required if you're using versions of Sodium lower than 0.6)

Note: versions of Sodium lower than 0.6 are known to cause Z-fighting issues when combined with Continuity.

Option 3 (1.18 to 1.21.5)

Option 4 (Not recommended)

Supported Mods

This is a list of mods that Glowing Emissive Ores supports.

None of the below mods are required for it to work.

    Instructions

    There are currently 4 Minecraft Modloaders: NeoForge, Forge, Fabric, and Quilt. You will need to install different requirements depending on which Modloader you are using. I have listed all the possible combinations you can use for each Modloader in the requirements tab.

    Confused? Here's an example:

    I plan on playing a Forge modpack: First, I install "Glowing Emissive Ores", then test if it works (some packs come pre-installed with the requirements). If it doesn't work, then come back to this site and select the requirements tab. Next, I will choose either Option 1, 2, 3, or 4 depending on the version of Minecraft I am playing on. If I choose option 1, I will need to install both "MoreMCMeta (Forge)" and "MoreMCMeta Emissive Textures (Forge)". Finally, I will load the modpack up again and test it. For most modpacks, this should work.

    Troubleshooting

    • If the modpack crashes — try launching it at least three times, as large modpacks are sometimes prone to random crashes during startup.
    • If the ores aren’t glowing or the modpack continues to crash — try a different option from the requirements list until you have tried all possible options. (If you've got Sinytra Connector installed the only options that will work are fabric mods like Continuity)
    • If you're using shaders and the ores only glow at certain times — look for a shader setting called “Floodfill” and disable it. Alternatively, use a different emissive ores resource pack that supports "LabPBR."
    • If the ores are flickering (a Z-fighting issue caused by pre-0.6 versions of Sodium conflicting with Continuity) - Try switching to a different requirements option (the Fusion option doesn't have this issue when combined with sodium).
    • If you're still experiencing issues — feel free to leave a comment on my CurseForge page or join my Discord for quicker support.